When buying tires, it is important to pay attention to specifications

When buying a tire, pay attention to the model marked on it, such as: 1200R20 (there are many marks on the tire, such as tire pressure, speed, etc.. Due to the reasons of length, I will not repeat them here), the 1200 is the tire cross section 12 inches; R is the meridian structure, generally all steel wire; 20 is the assembly wheel is 20 inches. When buying, be sure to pay attention to the load of your vehicle, road surface and other conditions to buy tires. Here, Zhongda Tire recommends that all card friends choose better tires as much as possible when the economy permits. Not only is safety and after-sales guaranteed, the driving safety and cost of the vehicle will also be reduced a lot.

Before the tires hit the road, it is essential to do a good job of anti-sticking

After the tires were purchased, the card friends who might not pay attention to them were directly loaded into the car for use. Wait until the tire is flat during use, only to find that the inner tube and the outer tube are firmly stuck together. After exhausting his efforts, he finally pulled out the inner tube-only part of the inner tube, and some of it stuck to the outer tube. This requires us to disassemble the tires before they are loaded on the car. The common method now is to sprinkle talcum powder between the inner and outer tires for isolation.

The quality of the rim should be guaranteed

With good tires, you must also choose wheels of better quality. When we choose a rim, we must pay attention to its size and quality. After cleaning up the impurities on the rim (no debris must be left inside), apply soapy water to the rim for a week, and then combine the tires. At this time, you also need a suitable tire pad to reduce the wear of the tire and rim.

Tire pressure standard is knowledgeable, reasonable inflation and loss reduction

Each tire is marked with its tire pressure value. There is a widespread phenomenon of unreasonable inflation in order to overload in China, which is not acceptable. If the tire pressure is too high or too low, it will lead to increased wear of the tread and even a flat tire. We can increase the tire pressure by 5% ~ 10% according to the tire pressure standard, and pressurize each tire reasonably according to the load of each shaft. It is worth noting that the tire pressure on the coaxial must be consistent. In the daily driving process, it is also necessary to check frequently to ensure the normal use of tires.